48" Model - Insignia ROKU TV NS-24ER310NA17 User Manual

NS-24ER310NA17/NS-24ER310CA17
NS-32DR310NA17/NS-32DR310CA17/NS-48DR510NA17

48" model

Note
If your TV is the 24" or 32" model, go to
On your TV
Coaxial cable
connector
ANT/CABLE IN
jack
1 Make sure that your TV's power cord is unplugged and all connected devices are turned off.
2 Connect a coaxial cable (not provided) to the ANT/CABLE IN jack on the side of your TV and to the antenna or cable
TV wall jack.
3 Plug your TV's power cord into a power outlet, then turn on your TV.
4 On the Home menu, press
5 Set up the TV tuner to watch broadcast TV. See
6 On the Home screen, press
Notes
• Use a coaxial cable to eliminate interference and noise from radio waves.
• Do not bundle the coaxial cable with the power cord or other cables.
• If the antenna is not installed correctly, contact qualified service personnel to correct the problem.
• If the signal level for a channel is weak, the picture may be distorted. Adjust the antenna or use a
highly directional outdoor or set-top antenna with a built-in amplifier.
• If the picture quality is good on some channels and poor on others, the problem may be caused by
a poor or weak signal from the broadcaster or cable TV provider.
• If you connect to cable TV without a set-top box and experience poor picture quality, you may
need to install a set-top box to improve signal reception and picture quality. Contact your cable TV
provider about upgrading to a set-top box.
• Many high-definition (HD) channels upscale standard-definition (SD) content. The picture
displayed on your TV is still displayed as SD, thus the picture quality will not be as clear or crisp as it
would be if the content was originally recorded in HD.
34
Antenna or
cable TV (no
box)
or the highlight the tile for Antenna TV, then press OK.
or to highlight the Antenna TV tile, then press OK.
www.insigniaproducts.com
24" or 32" model on page 33.
Coaxial cable
Setting up Antenna TV on page 65.
Side of TV