ip http
ip ip-prefix
ip route-static
lacp system-priority
link-aggregation group agg-
id description
link-aggregation group agg-
id mode
local-server
local-user
local-user password-display-
mode
loopback-detection enable
loopback-detection interval-
time
mac-address
mac-address timer
mac-authentication
mac-authentication authmode
mac-authentication
authpassword
mac-authentication
authusername
mac-authentication domain
mac-authentication timer
memory
password-control
password-control enable
password-control super
poe disconnect*
poe legacy enable*
poe power-management*
poe temperature-protection
enable*
poe update*
private-group-id
qos cos-local-precedence-map
queue-scheduler
Configure HTTP
Configure an address prefix list or one of its items
Configure a static route
Configure LACP system priority value
Configure a descriptor for an aggregation group
Create a manual or static aggregation group
Specify local RADIUS server configuration
information
Specify local user configuration and enter local-user
view (See
Table 5, "Local-user View," on page
Specify password display mode
Enable port loopback detection
Configure the detection interval for the external
loopback condition of each port
Configure MAC address
Configure the aging time of the Layer-2 dynamic
address table entry
Enable the centralized MAC address authentication
feature on a specified port or globally
Specify MAC authenticate authmode config
Specify the fixed password
Specify the fixed username
Configure the ISP domain used by the centralized
MAC address authentication user
Configure timer parameters of the centralized MAC
address authentication
Free memory for routing protocols to run normally
Specify password controls
Enable Password Controls
Super user's password controls
Set PoE disconnect mode
Enable Legacy detection
Power Management
Over Temperature Protection
Update PoE firmware
Tunnel Private Group ID attribute description mode
Configure "CoS Local-precedence" mapping table
Specify queue scheduling mode and parameters
11
Security -> Authorized IP
Device -> IP Route
Port -> LACP
Port -> Link Aggregation
Port -> Link Aggregation
Administration ->
14)
System Access
Need help?
Do you have a question about the SUPERSTACK 3 4500 and is the answer not in the manual?
Questions and answers