3Com SUPERSTACK 3 4500 Quick Reference Manual page 19

rip metricout
rip output
rip split-horizon
rip version
rip work
shutdown
udp-helper server
Table 16 Ethernet Port View
[4500]interface ethernet 1/0/1
Command
am ip-pool
arp static
broadcast-suppression
description
dot1x max-user
dot1x port-control
dot1x port-method
dot1x supp-proxy-check
duplex
enable snmp trap
flow-control
igmp
jumboframe enable
lacp enable
lacp port-priority
line-rate
loopback
loopback-detection control
enable
loopback-detection enable
loopback-detection per-vlan
enable
Configure the additional route metric to the route
when an interface transmits RIP packets
Allow an interface to transmit RIP packets to the
network
Configure an interface to use split horizon when
transmitting RIP packets
Configure the RIP version of RIP packets on an
interface
Enable the running of RIP on an interface
Disable the VLAN interface
Configure the relay destination server
Description
Configure the IP address pool for access
management on a port
Configure the static ARP mapping entries in an ARP
mapping table
Configure the broadcast traffic size enabled on port Port -> Administration
Configure name for a port
Specify maximal on-line user number per port
Specify port authenticated status
Specify port controlled method
Check whether user(s) access the networks by proxy
or not
Configure the duplex mode of the port
Enable/disable current port to transmit the LINK UP
and LINK DOWN trap information
Enable flow control on the Ethernet port
IGMP Ethernet port configuration
Allow jumbo frames to pass through the current
port
Enable LACP
Configure port priority value
Limit the total rate of the packets delivered by
interfaces
Configure the Ethernet port to perform the
loopback test
Enable loopback detection control function on a
trunk or hybrid port
Enable port loopback detection
Configure loopback detection on all VLANs on
trunk and hybrid ports
19
Device -> VLAN Interface
Web Command
Port -> Administration
Port -> Administration
Port -> Administration
Port -> LACP
Port -> LACP
Tools -> Loopback