46
G8264CS Installation Guide
To install the G8264CS in an iDataPlex rack, complete the following steps:
1. Locate, record, and retain the product switch information in order to configure
and register your product. See
page
34.
Note: If this switch is a replacement switch, copy the product information from the
original switch onto the RID label that is shipped with replacement switch
and affix the new label to the bottom of the new switch.
2. Remove the rear cover screws:
3. Attach front mounting brackets (Item 1) and rear mounting brackets (Item 6) to
each side of the switch with M4 screws (Item 2). Torque the screws to
approximately 2 newton-meters (Nm) +/- 0.1 Nm (17.7 inch-pounds).
4. From the front, slide the switch into the rack at the desired height.
"Recording Important Product Information" on
1
6
2