Brother HL-L6250DW Online User's Manual page 250

Error Message
Print Unable ##
Replace Toner
Screen Init. Fail
Self-Diagnostic
Size Error
Size Error 2-sided
Size Mismatch
Supplies
Drum End Soon
Supplies
Replace Drum
Supplies
Toner Low
Cause
The machine has a mechanical
problem.
The toner cartridge is at the end of
its life. The machine stops all print
operations.
The Touchscreen was pressed
before the power on initialization
was completed.
Debris may be stuck between the
lower part of the Touchscreen and
its frame.
The temperature of the fuser unit
does not rise to a specified
temperature within the specified
time.
The fuser unit is too hot.
The paper size defined in the
printer driver is not supported by
the defined tray.
The paper size specified in the
machine's paper size setting is not
available for automatic 2-sided
printing.
The paper in the tray is not the
correct size and is not available
for automatic 2-sided printing.
The paper in the tray is not the
correct size.
The drum unit is near the end of
its life.
It is time to replace the drum unit.
The drum unit counter was not
reset when a new drum was
installed.
If the LCD displays this message,
you can still print. The toner
cartridge is near the end of its life.
Action
• Press and hold to turn off the machine,
wait a few minutes, and then turn it on
again.
• If the problem continues, contact Brother
Customer Service.
Contact Brother Customer Service at:
1-877-BROTHER (1-877-276-8437) (in
USA)
www.brother.ca/support
or to locate a Brother Authorized Service
Center, visit:
http://www.brother-usa.com/service
Replace the toner cartridge with a new one.
Make sure nothing is touching the
Touchscreen.
Insert a piece of stiff paper between the lower
part of the Touchscreen and its frame and
slide it back and forth to push out any debris.
Press and hold to turn off the machine,
wait a few seconds, and then turn it on again.
Leave the machine idle for 15 minutes with the
power on.
Choose a paper size supported by the defined
tray.
Press (if required).
Load the correct size of paper in the tray and
set the tray for that paper size.
Choose a paper size supported by 2-sided
printing.
Paper sizes available for automatic 2-sided
printing are Letter, Legal, Mexico Legal, India
Legal and Folio.
Load the correct size of paper in the tray
indicated on the LCD and set the size of paper
for the tray. Press Retry.
Order a new drum unit before the LCD
displays Replace Drum.
Replace the drum unit with a new one.
See Related Information: Replace the Drum
Unit.
Reset the drum unit counter.
See the instructions included with the new
drum unit.
Order a new toner cartridge now so you have
it ready when the LCD displays Replace
Toner.
(in Canada)
245