Brother HL-L6250DW Online User's Manual page 106

Click (Start) > Network > Add a wireless device.
®
• (Windows 7)
Click (Start) > Devices and Printers > Add a device.
®
• (Windows 8)
Move your mouse to the lower right corner of your desktop. When the menu bar appears, click Settings >
Control Panel > Hardware and Sound > Devices and Printers > Add a device.
• To use a Windows Vista
your network in advance. For more information, see the instructions supplied with your wireless LAN
access point/router.
• If you use Windows
configuration by following the on-screen instructions. To install the full driver and software package, use
the Brother Installation CD-ROM.
9. Select your machine and click Next.
10. Type the PIN displayed on the machine's LCD, and then click Next.
11. Select your network, and then click Next.
12. Click Close.
If your wireless device is connected successfully, the machine's LCD displays [Connected].
You have completed the wireless network setup. To install drivers and software necessary for operating your
device, insert the Brother Installation CD-ROM to your computer or go to your model's Downloads page on the
Brother Solutions Center at
device.
HL-L6400DW/HL-L6400DWT
1. Press [Settings] > [Network] > [WLAN] > [WPS w/PIN Code].
2. When [Switch network interface to wireless?] appears, press [Yes].
This will start the wireless setup wizard. To cancel, press [No].
3. The LCD displays an eight-digit PIN and the machine starts searching for a wireless LAN access point/router.
4. Using a computer that is on the network, type "http://access point's IP address" in your browser (where
"access point's IP address" is the IP address of the device that is being used as the Registrar).
5. Go to the WPS settings page and type the PIN, and then follow the on-screen instructions.
• The Registrar is usually the wireless LAN access point/router.
• The settings page will differ depending on the brand of wireless LAN access point/router. For more
information, see the instructions supplied with your wireless LAN access point/router.
If you are using a Windows Vista
following steps:
6. Do one of the following:
®
• (Windows Vista
Click (Start) > Network > Add a wireless device.
®
• (Windows 7)
Click (Start) > Devices and Printers > Add a device.
®
• (Windows 8)
Move your mouse to the lower right corner of your desktop. When the menu bar appears, click Settings >
Control Panel > Hardware and Sound > Devices and Printers > Add a device.
® ®
, Windows 7, or Windows
® ®
7 or Windows 8 as a Registrar, you can install the printer driver after the wireless
support.brother.com
®
, Windows
)
®
8 computer as a Registrar, you must register it to
to install drivers and software necessary for operating your
® ®
7, or Windows 8 computer as a Registrar, complete the
101