Replace The Dome Cover; Install An Sd Card - Axis P55-E Series Installation Manual

AXIS P55-E Network Camera Series
3. To replace the clear/smoked dome cover, see page 14. To install an SD card see page 14.
4. Put the top cover back in its original position and fasten two diagonally opposite screws
first (torque < 0.7 Nm), and then the two other screws.

Replace the Dome Cover

Important
This product has a dehumidifying membrane to maintain low humidity levels inside the
dome. To avoid condensation, do not disassemble the camera in rain or in damp conditions.
Note
Be careful not to scratch or damage the dome cover. If possible, keep the protective plastic
on the dome cover until the installation is complete.
Replacing the dome cover is only necessary if you want to use a smoked dome cover or if the
dome cover is scratched or damaged. Smoked dome covers and spare clear dome covers can be
purchased from your Axis reseller.
See Hardware Overview on page 9 for location of components.
1. Loosen the top cover screws and remove the top cover.
2. Remove the 8 dome ring screws and remove the dome ring from the top cover.
3. Attach the dome ring and the replacement dome cover to the top cover and secure by
tightening the screws (torque 0.4 to 0.6 Nm).
4. To install an SD card (not included), see page 14.
5. Put the top cover back in its original position and fasten diagonally two opposite screws
(torque < 0.7 Nm), and then the other screws.

Install an SD Card

NO NO TICE NO TICE TICE
To prevent corruption of recordings, the SD card should be unmounted before it is ejected.
To unmount, go to Setup > System Options > Storage > SD Card and click Unmount.
It is optional to install a standard or high capacity SD card (not included), which can be used for
local recording with removable storage.
See Hardware Overview on page 9 for location of components.
1. Remove the sunshield.
2. Loosen the 4 top cover screws and remove the top cover.
3. Insert an SD card (not included) into the SD card slot.
14