Connecting Combustion Air Hose (Air Supply) - Rinnai RHFE-308FTR Installation Manual

CONNECTING HEATER EXHAUST & AIR SUPPLY
The models 308 & 309 do not have a slide tube and therefore do not need a retaining mechanism
for the slide tube. The 556, 557 and 1004 are fitted with a fixing clamp refer to Fig. 5, to stop
NOTE
accidental disconnection of the slide tube. The 559 / 561 has the retaining mechanism built in to
the slide tube assembly refer Fig. 4.
Maximum limit of tube extension
INCORRECT over extension of tube
4
4. Use the adjustable telescopic tube of the exhaust pipe to attain the desired position of the heater,
extend the telescopic tube beyond the indicator groove.
5. Fix the telescopic tube of the exhaust pipe in place with the flue lock.
attached to the telescopic tube whilst the finger tabs are secured around the collar of the fixed flue spigot.
This joint MUST be properly secured in accordance with these instructions using the flue
lock provided when applicable. If the joint is not properly secured, products of combustion could
CAUTION
disperse into the room being heated. Which may result in a dangerous condition.

CONNECTING COMBUSTION AIR HOSE (AIR SUPPLY)

Connection of the combustion air hose for a IN-WALL installations is described refer to page 24.
NOTE
Models 308,309,556,557,559
and 561
The combustion air hose of all Energysaver heaters is attached to the small diameter combustion air inlet.
Secure the combustion air hose to the combustion air inlet with cable tie supplied with the
heater.
CAUTION
The air hose MUST be properly secured in accordance with these instructions for safe and
reliable operation of this heater.
The rubber cap (when fitted) is designed to fit both the left and right hand combustion air inlet
and MUST cover the air inlet not in use.
Rinnai Australia
Note: Clamp
1005 Model
!
!
!
26
NOT
used on
!
Collar
5
The clamp of the flue lock is
Models 1004 and 1005
Collar
DO NOT
!
!
!
ES Flue Installation Manual