4
4.
In the top plate directly above the transition assembly cut a hole for the flue path,
MUST NOT exceed 150mm. Ensure that the transition assembly is covered to prevent debris entering.
Lubricate the O-Ring of the condensate trap and
required lengths of ESPIPE900 to reach but not pass through the top plate,
additional ESPIPE900 length before fitting. When this point is reached
hole in the top plate.
5. Continue Flueing to the termination point and fit an ESROOFCOWL observing the clearances and regulations
refer to page 4. To avoid obstructions in the flue path a horizontal offset can be created using ESBEND.
6. Pass the combustion air hose of the heater through the right hand vermin plate.
Rinnai Australia
FLUE COMPONENT ASSEMBLY
5
with the male ends pointing towards the heater fit the
secure the top plate bracket over the
23
the maximum width
lubricating the O-Rings of each
ES Flue Installation Manual