Table of Contents
Advertisement
VMT7000 series
4.5 Network connection (RJ45)
If the drivers required for functioning are installed on the device, the control system may be integrated in
an Ethernet network supporting the 10/100/1000Mbit/s standard by using the Ethernet 10/100/1000
BaseT network connector. The specifications of this network topology must be observed. If the drivers
necessary for the function are not installed, they can be downloaded from the website (www.ads-
tec.de/downloads).
Pin
1
2
3
4
5
6
7
8
Recommendation for use:
The device has two separately installed network controllers of the Realtek
RTL 8111c Family PCIe Gigabit Ethernet type.
Recommendation for use:
PXE booting is only possible by using the LAN1 port.
Pos : 32 /D atentec hni k/Schnitts tell en/Funknetz wer kkar te/Funknetz wer kkarte für VMT 6000 Serie @ 2\mod_1260517076470_6.doc @ 6872 @
© ads-tec GmbH • Heinrich-Hertz-Str. 1 • 72622 Nürtingen • Germany
Signal
MDI0+
MDI0-
MDI1+
MDI2+
MDI2-
MDI1-
MDI3+
MDI3-
17
Advertisement
Table of Contents
