CBS-72ATC - Twin Coffee Brewer with transfer system and mobile dispensers. Specifications Average Brew Time: 7 minutes (Allow an extra 3-5 minutes for coffee to finish dripping Coffee Filters: 23” X 9” FETCO # F006 Total Weight, Dispenser LBD-6 Weight filled 150 lbs.
Electrical Configuration and Brewing Efficiency CBS-71A & AC Heater Model Configuration CBS-71A (-1) 3 X 5 KW CBS-71A (-2) 3 X 10 KW CBS-71A (-3) 3 X 10 KW A and AC versions are actually identical units. The only difference is the stand or counter upon which the unit is placed.
Page 4
AT and ATC versions are actually identical units. The only difference is the stand or counter upon which the unit is placed. Steam Heated Brewers Maximum Model Steam Demand CBS-71A/AC (-4) 80 lbs./hr. CBS-72A/AC (-6) 160 lbs./hr. Customer supplies one ¾ inch steam line. No power management between sides. CBS-72A/AC (-7) 80 lbs./hr.
• Utilize a qualified beverage equipment service technician for installation. Brewer Installation The installation must comply with applicable federal, state, and local codes having jurisdiction at your location. Check with your local inspectors to determine what codes will apply to the installation and operation of FETCO products. Brewer Set-up •...
• CBS-71A - press the power switch. CBS-72A - press only the power switch on the brewer’s left side. The power switch will illuminate. After a delay of 5-6 seconds, the tank should begin filling with water. •...
Page 7
Transfer System (AT versions only) Holding Tank Set-up • Place the tank stand in the desired location. • Using a carpenter’s level, adjust the legs until the stand is perfectly level front-to-back, and left-to-right. • Each leg has a flange with 2 holes for bolting the stand to the floor (required for safety). Mark the location of the holes on the floor.
Brewing System Before brewing, always verify the cleanliness of the brew baskets and dispensers. 1. Push the POWER switch to the ON position • The button will illuminate to indicate that the brewer has power and is operational. 2. Prepare the brew basket(s). •...
Transfer System 1. Before Brewing • Remove the sight gauge vent cap from the dispenser you want to transfer, and insert the transfer hose into the top of the sight gauge. • Ensure that the dispenser, brew basket, and holding tank cover are in place, and that all old coffee has been drained from the holding tank and dispensers.
Drip Delay (Min:Sec) Auto Transfer Pump Water Temp. (°F) Brew Wait Standard factory settings apply unless custom settings were requested at the time of order. Non-standard size brew orifices must be ordered from FETCO. Programming Standard Factory Range Increment Five available sizes: .250,...
Daily Before brewing, always verify the cleanliness of the brew baskets and dispensers. At the end of the day, remove the brew basket and wipe the bottom of the spray pan with a cloth to remove the coffee oils that have collected. Brew &...