Table of Contents
Advertisement
Controller Settings
With an EnGenius EWS switch or ezMaster management, user can add the Access Point to the management list by its check code.
Controller Address: Input the IP address of the EnGenius EWS switch or ezMaster, then click "Test."
Connection Status: After clicking "Test," it will display the connection between the Access Point and the EnGenius EWS switch or ezMaster.
SNMP Settings
This page allows you to assign the Contact Details, Location, Community Name, and Trap Settings for Simple Network Management Protocol (SNMP).
This is a networking management protocol used to monitor network-attached devices. SNMP allows messages (called protocol data units) to be sent
to various parts of the network. Upon receiving these messages, SNMP compatible devices (called agents) return the data stored in their
Management Information Bases. To configure SNMP Settings, click under the Advanced tab on the side bar under Management.
Advertisement
Table of Contents
