Spirit XE395 ELLIPTICAL SPT0065 Owner's Manual page 9

STEP 2: Connecting & Lower Swing Arms
1. Slide two Wave Washers (150) onto each side of the Swing Arm Axle. Slide the Lower Swing Arms (10
Left, 11 Right) onto the axles and secure with the two
Do not force the Swing Arms onto the axle. They should slide on, but you may need to jiggle them to
get them lined up properly. The Swing Arms have been previously installed at the factor y so they do fit
properly.
2. Remove the tie that holds the spacer in the rod end located at the end of the Right Connecting Arm (9)
and line up the rod end with the bracket at the bottom of the Lower Right Swing Arm (11). Slide the
Head Bolt (186)
Install the Flat Washer (142) and Nyloc Nut
this step for the left side. Tighten using the Wrenches (155 & 158).
HARDWARE
#150. Ø 17 m/m
Wavy Washer (4 pcs)
#184. 5/16" × 15mm
Hex Head Bolt (2 pcs)
through the bracket of the Lower Swing Arm and then through the rod end and spacer.
#141. 5/16" × 23 × 1.5T
Flat Washer (2 pcs)
#186. 5/16" × 1- 1/4"
Hex Head Bolt (2 pcs)
Hex Head Bolts (184)
on the bolt and tighten as much as possible. Repeat
(192)
#142. 5/16" × 20 × 1.5T
Flat Washer (2 pcs)
8
and Flat Washers (141).
#192. 5/16" × 9T
Nyloc Nut (2 pcs)
Hex