Spirit XE395 ELLIPTICAL SPT0065 Owner's Manual page 10

STEP 3: Upper Swing Arms
1. Slide the Rubber Sleeve (162) onto the left (16) and right (17) Upper Swing Arms. Make sure the wide
part is at the bottom.
2. Attach the wire (55) from the Right Upper Swing Arm (17) to the wire (57) that exits the Console Mast
tube (12). Slide the Switch Wire Cap (161) onto the wire with the wide side facing the Swing Arm.
3. Attach the wire (56) from the Left Upper Swing Arm (16) to the wire (57) that exits the Console Mast
tube (12). Slide the Switch Wire Cap (161) onto the wire with the wide side facing the Swing Arm.
4. Insert the Upper Swing Arm (17) into the Lower Swing Arm. Fasten together with three Hex Head Bolts
(159), two Curved Washers (160), and three Nyloc Nuts (127).
5. Repeat step 3.3 from above on the left side.
HARDWARE
#160. 5/16" × 23 × 1.5T
Curved Washer (4 pcs)
#159. 5/16" × 1-3/4"
Hex Head Bolt (6 pcs)
#127. 5/16" × 7T
Nyloc Nut (6 pcs)
9
#161. Switch Wire Cap
(2 pcs)