Spirit XE395 ELLIPTICAL SPT0065 Owner's Manual page 11

STEP 4: Plastic Parts
1. Install the two Wheel Covers (79-Left & 80-Right) with four Phillips Head Screws (115).
2. Install the Center Cover (85) with two Phillips Head Screw (115). You need to raise the incline to install
the Center Cover.
3. Install the Swing Arm End Cap Covers (81 & 82-Left, 83 & 84-Right) with the eight Sheet Metal Screws
(119).
4. Install the two 'Z' shaped metal brackets (180) as shown with four Phillips Head Screws (122). The Z
Brackets should be installed so the tab with the tapped hole is pointing toward the rear.
5. Install the Rear Incline Cover (87) with two Phillips Head Screws (115). Install the Rear Stabilizer Cover
(88) with four Phillips Head Screws (115).
HARDWARE
#119. 3.5 × 12mm
Sheet Metal Screw
(8 pcs)
#115. M5 ×15mm
Phillips Head Screw
(12 pcs)
10
#122. M6 × 10mm
Phillips Head Screw
(4 pcs)