Copying Data Using The Front Usb Port - Fujitsu CELVIN NAS QE705 Operating Manual

Copying data using the front USB port

Copying data using the front USB port

Data can be copied directly from an external drive to the NAS or vice versa by pressing the one-
touch copy button on the front of the device. To use this function, follow the steps below:
► Make sure a hard disk has been installed and formatted in the NAS. This will create the USB
standard network share.
► Switch on the NAS.
► Configure the function of the one-touch copy button on the page Backup - USB One Touch Copy.
► Connect the USB drive (e.g. digital camera or flash drive) to the front USB port on the NAS.
► Press the one-touch copy button. Data will be copied to the NAS according to the previously
defined settings.
QE705
1 = One-touch copy button
2 = USB 3.0
30
STATUS
LAN
USB
HDD1
HDD2
1
2
Fujitsu