Installing The Nas; List Of Recommended Hard Disks; System Ventilation - Fujitsu CELVIN NAS QE705 Operating Manual

Installing the NAS

For information on hard disk installation and initial operation, please refer to the "Quick Start Guide".
To install the NAS, proceed as follows:
► Switch on the NAS.
► Connect the NAS to the same network as your PC.
To make sure that the NAS works correctly, pay attention to LEDs and alarm buzzer
!
sounds during installation.
See "System status checks" for more information.

List of recommended hard disks

This product will work with 2,5/3,5 inch SATA hard disks from major hard disk manufacturers. A list of
compatible drives can be found at http://support.ts.fujitsu.com.
Fujitsu Technology Solutions will accept no liability whatsoever for any product
!
defects/faulty operation, and/or any time and costs associated with data loss/data
recovery, insofar as the cause can be attributed to misuse or improper installation of hard
disks, regardless of the circumstances or for whatever reason.
Please note that when installing a hard disk (new or used) which has not previously been
!
installed on the NAS, the hard disk will first be formatted and sub-divided automatically,
and all disk data will be lost.

System ventilation

Please ensure when setting up the device that sufficient ventilation will be available at all times. The
air inlet of the product must not be covered, as otherwise it is not possible to guarantee that the
system will receive sufficient ventilation, which may lead to the product being damaged.
Fujitsu

Installing the NAS

11