22
Switch on the TV
It takes the TV approx. 20 seconds to start up and
become ready for use.
Select settings
You are led through the First-time setup sequence
when you switch on the TV for the first time.*
Some menus may not appear depending on your
setup.
Information
Connections
Select the type of equipment connected to each socket, the sockets used,
the product name, and the source name.
First-time setup of your television
This first-time setup procedure is activated when the TV is connected to the mains
and switched on for the first time. If you want to change your setup at a later date,
you can access the same menus and update your settings.
TV
Switch on
or
Select setting
1
MENU LANGUAGE
TUNER SETUP
STANDBY SETTINGS
CONNECTIONS
AUTO TUNING
This Getting Started describes operation with Beo4 in MODE 1 and the BEO4 SETTING menu set to
NAVIGATION BUTTON, see also page 9.
Please remember to set your Beo4 with navigation button to the MODE corresponding to the setting
you make in the BEO4 SETTING menu, see the Beo4 Guide for further information.
Accept and go to next menu item
Set the on-screen menu language
Disable or enable internal TV tuner or DVB
Make standby settings for the TV
Register connected equipment
Tune in TV channels automatically. Available only if the TV tuner is
enabled. See the Guide for further information.
1
*NOTE! When you have selected the preferred
settings in a menu, you may have to press the
green button to continue to the next menu in the
first-time setup procedure. Follow the on-screen
instructions.