Table of Contents
Advertisement
ELECTRICAL ADJUSTMENT-9/13
[Setting TV/measuring equipment] H POS 60 simplified adjustment
ADJUSTMENT MENU No.
INPUT SIGNAL
SPEC
MODE
d
1. Use the pattern generator and input the crosshatch signal.
2. Use the [VOLUME +/-] of the jig remote control and adjust so that the dot mark at the
center of crosshatch screen is positioned at the center mark on CRT and the numbers of
squares in the right and left on the screen are equal (A=B). (Fig. 2-2.)
2-2. V POS 60 NTSC vertical position adjustment
[Setting TV/measuring equipment]
ADJUSTMENT MENU No.
INPUT SIGNAL
p
SPEC
MODE
1. Use the monoscope and input the LION mark.
2. Use the [VOLUME +/-] key of the jig remote control and adjust so that the center lines of
the right most and left most edges on the monoscope screen match with the center mark
on CRT. (Fig. 2-3)
[Setting TV/measuring equipment]V POS 60 simplified adjustment
ADJUSTMENT MENU No.
INPUT SIGNAL
SPEC
MODE
t
1. Use the pattern generator and input the crosshatch signal.
2. Use the [VOLUME +/-] key of the jig remote control and adjust so that the dot mark at
the center of crosshatch matches with the center mark on CRT. (Fig. 2-4)
2-3. V SIZE 60 NTSC vertical size adjustment
[Setting TV/measuring equipment]
ADJUSTMENT MENU No.
INPUT SIGNAL
SPEC
MODE
1. Use the monoscope and input the LION mark.
2. Use the [VOLUME +/-] key of the jig remote control and adjust until the number of
vertical scale in both top and bottom of screen satisfy the specification. (Fig. 2-5)
−
MENU2 1
NTSC crosshatch
A=B
VIDEO
−
MENU2 2
NTSC monoscope
CRT center = monoscope center line
VIDEO
−
MENU2 2
NTSC crosshatch
The center on CRT matches with the center of crosshatch.
VIDEO
−
MENU2 3
NTSC monoscope
Vertical graduation is 3.5 to 4.5 (90% to 94%)
VIDEO
r
-44-
CENTER
A
u
Fig.2-2
NTSC cross hatch
a
Fig.2-3 NTSC monoscope
o
Fig.2-4 NTSC cross hatch
Fig.2-5 NTSC monoscope
B
Advertisement
Table of Contents
