Table of Contents
Advertisement
ELECTRICAL ADJUSTMENT-8/13
[Setting TV/measuring equipment] V LINE 50 simplified adjustment
ADJUSTMENT MENU No.
INPUT SIGNAL
SPEC
MODE
d
1. Use the pattern generator and input the CONVERGENCE signal.
2. Use the [VOLUME +/-] key of the jig remote control and set the value to either 1D, 1E or
1F, and confirm that the crosshatch square is a regular square. (Fig. 1-8)
Note : Upon completion of adjustment, check V POS 50 (MENU 1 to 2) and V SIZE 50
(MENU 1 to 3). If they do not satisfy the specifications, re-adjust them.
1-5. OSD H 50 PAL OSD horizontal position adjustment
[Setting TV/measuring equipment]
ADJUSTMENT MENU No.
INPUT SIGNAL
SPEC
MODE
p
1. Use the pattern generator and input the CONVERGENCE signal.
2. Adjust each distance of A (from
screen) so that they are equal. (Fig. 1-9)
1-6. OSD V 50 PAL OSD vertical position adjustment
[Setting TV/measuring equipment]
ADJUSTMENT MENU No.
INPUT SIGNAL
SPEC
MODE
t
1. Use the pattern generator and input the CONVERGENCE signal.
2. Adjust each distance of A (from
on screen) so that they are equal. (Fig. 1-10)
5-2. Screen Size and Screen Position Adjustments
2-1. H POS 60 NTSC horizontal position adjustment
[Setting TV/measuring equipment]
ADJUSTMENT MENU No.
INPUT SIGNAL
SPEC
MODE
1. Use the monoscope and input the LION mark signal.
2. Use the [VOLUME +/-] key of the jig remote control and adjust so that both right and left
horizontal graduations are equal. (Fig. 2-1)
−
MENU1 4
PAL CONVERGENCE
Regular square
VIDEO
−
MENU1 5
PAL CONVERGENCE
A = B
VIDEO
to left edge on screen) and B (from
−
MENU1 6
PAL CONVERGENCE
A = B
VIDEO
to top edge on screen) and B (from
−
MENU2 1
NTSC
monoscope
The numbers of horizontal scales in the right and
left on the screen are equal.
r
VIDEO
to right edge on
to bottom edge
-43-
u
Fig.1-8
PAL CONVERGENCE
a
A
Fig.1-9
PAL CONVERGENCE
A
o
B
Fig.1-10
PAL CONVERGENCE
Fig.2-1 NTSC monoscope
B
Advertisement
Table of Contents
