Traxxas Summit Owner's Manual

Traxxas Summit Owner's Manual

Hide thumbs Also See for Summit:

Advertisement

MODEL 56076-4
owner
s manual
'

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Summit and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Traxxas Summit

  • Page 1 MODEL 56076-4 owner s manual ’...
  • Page 2 DRIVING YOUR MODEL it’s important to read and follow the procedures in this manual. TUNING Thank you again for going with Traxxas. We work hard every day ADJUSTMENTS to assure you the highest level of customer satisfaction possible. We truly want you to enjoy your new model!
  • Page 3 Traxxas service needs. Maintenance and replacement Throughout this manual, you’ll notice warnings and helpful hints Ready-To-Race, TQ, Titan, Summit, parts may be purchased directly from Traxxas by phone or online and EVX-2 are trademarks or identified by the icons below. Be sure to read them! registered trademarks of Traxxas.
  • Page 4 = Myriad Semi Bold SAFETY PRECAUTIONS All of us at Traxxas want you to safely enjoy your new model. • Transmitter on First: Switch on your transmitter first before Operate your model sensibly and with care, and it will be exciting,...
  • Page 5: Fire Hazard

    LiPos. on the risks associated with LiPo battery use. Traxxas does not • Store and transport your battery pack(s) in a cool dry place.
  • Page 6 If eye or skin contact occurs, flush with water. times. • If a battery gets hot to the touch during the charging process (temperature greater than 110°F / 43°C), immediately disconnect the battery from the charger and discontinue charging. 6 • SUMMIT...
  • Page 7 R/C toolbox: • Safety glasses • Traxxas Ultra Premium Tire Glue, Part #6468 (CA glue) • Hobby knife • Side cutters and/or needle nose pliers 17mm wheel wrench 2.0mm “T”...
  • Page 8 Electronic Speed Control Battery Door Release Tab Pivot Ball Steering Servo Axle Carrier Traxxas High-Current Connector Front T-Lock Servo Push Rod Motor Rocker Slipper Clutch Rear Body Mount Transmission Front Body Chassis Mount Rear Bumper Shock...
  • Page 9 Make a habit of turning the transmitter on first and off last. Follow these critical steps to maintain the performance of your model and keep it in excellent running condition. Look for the Quick Start logo at the bottom of Quick Start pages. SUMMIT • 9...
  • Page 10: Radio System

    NiCad - Abbreviation for nickel-cadmium. The original rechargeable hobby pack, NiCad batteries have very high current handling, high capacity, Your model includes the latest Traxxas TQi 2.4GHz transmitter with Traxxas Applying the Decals and can last up to 1000 charging cycles. Good charging procedures are Link ™...
  • Page 11: Transmitter And Receiver

    Sensor Expansion (Channel 3) Port To Motor Throttle High-Current Trigger Battery Connector Link Button Heat Sinks Power Switch Battery Compartment EZ-Set Button SUMMIT • 11 ** Accessory sensor port for use with the Telemetry Expander Module (see Traxxas.com for more information)
  • Page 12: Installing Transmitter Batteries

    LiPo batteries equipped with Traxxas High-Current Connectors are green, check the polarity required. Traxxas Power Cell iD batteries are strongly recommended of the batteries. Check for maximum performance and safer charging. The following chart...
  • Page 13: Installing Battery Packs

    LiPo batteries. If you are using batteries that are very thick, the spring to maximize the output 7-cell NiMH stick packs or 2-Cell LiPo battery packs. The Summit battery clip may need to be removed from the battery compartment. of the EVX-2. The Traxxas compartments have three key features for keeping your batteries secure: connector’s gold-plated...
  • Page 14 The electronic steering trim located on the face of the transmitter adjusts the neutral (center) point of the steering channel. Note: Traxxas Stability Management (TSM) must be completely turned off while adjusting steering trim. See page 16 for TSM adjustments.
  • Page 15 WARNING: Do not apply full throttle in forward or reverse while the model is elevated. 8. Once adjustments are made, turn off the receiver on your model, followed by the hand-held transmitter. SUMMIT • 15...
  • Page 16 Confirm that the steering and Drive with TSM on and off to test how it is making your control of the throttle operate properly before driving your model. vehicle easier and more precise. For more information, visit Traxxas. TRAXXAS STABILITY MANAGEMENT (TSM) com/tsm.
  • Page 17: Adjusting The Electronic Speed Control

    The LED will turn off until full braking power is reached. At full 4. Release MENU and SET. The transmitter LED will blink red. will result. brakes, the LED will shine red. 5. Press MENU once. The transmitter LED will blink red twice repeatedly. SUMMIT • 17...
  • Page 18 If this does not restore normal operation, then the is returned to neutral, the EVX-2 (indicating the Profile numbers). EVX-2 is indicating the transmitter’s Throttle Trim (see page 29) is incorrectly will operate properly. set. Reset the throttle trim to the “0” position. 18 • SUMMIT *Patented...
  • Page 19: Driving Your Model

    T-Lock switch to • If the model becomes stuck against an object, do not continue to run the forward-most position. As with a full-size 4WD vehicle, Summit’s the motor. Remove the obstruction before continuing. Do not push or high-speed handling and steering precision are reduced when one or pull objects with the model.
  • Page 20 Although the Summit’s 775 motor has ample torque in second mechanical and electrical components to prevent corrosion of metal gear, using first gear in situations that require low speed will extend parts and maintain their proper function.
  • Page 21 4. Apply a small bead of silicone grease corroding internal steel components. • Stub axle housing bearings: Remove, clean, and re-oil the bearings. (Traxxas part #1647) to the wire clamp. • Front and rear differential: Remove, 5. Install the wire clamp and tighten the two disassemble, clean, and re-grease 2.5x8mm cap screws securely.
  • Page 22: Tuning Adjustments

    Summit’s ride height can be finely tuned by adjusting suspension sag via the preload adjusters on the shock bodies. Thread the preload A total of three different rocker arm sets are available for Summit. All adjuster down the shock body to raise Summit’s ride height, or thread will allow the wheel to travel a total of 90mm in the vertical direction.
  • Page 23 From the model is hopping over small bumps and feels unstable. The viscosity the factory, Summit is equipped with #2 pistons in the front and #2 of shock oil is affected by extremes in operating temperature; an oil of pistons in the rear.
  • Page 24 The lengths of the toe links can be piston bottoms out. adjusted by turning them with the included 5mm Traxxas wrench. 4. Lubricate the shaft and X-ring with silicone oil. Toe Base Factory Settings Install the X-ring over the shaft and into the bore of the shock body.
  • Page 25 Adjusting the Slipper Clutch with the most traction The Summit is equipped with From the factory, both of Summit’s differentials are filled with SAE • Racing on low-traction an adjustable Torque Control 100,000W viscosity silicone oil. Only use silicone oil in the differentials.
  • Page 26 26.96 28.26 29.57 match the needs of the Summit. The Titan is made to run efficiently the single motor mount screw with the at high voltage to provide more torque and longer run times. We provided 3mm wrench to slide the motor 24.89...
  • Page 27 TUNING ADJUSTMENTS DUAL SERVO STEERING SYSTEM T-LOCK SERVO INSTALLATION Summit uses dual-servo steering and a single heavy-duty servo saver for The Summit’s T-Lock differential control servos are installed and pre- powerful, responsive steering. To prevent unnecessary receiver battery set at the factory. If you need to remove the servos or the servo horns drain, it is important to make sure that the servos are “at rest”...
  • Page 28: Maintaining Your Model

    5. Check the mounting of the receiver and servo(s) and overtightening. If the bottom of the shock is leaking, then it speed control. is time for a rebuild. The Traxxas rebuild kit for two shocks is 6. Check the tightness of the wheel nuts with a wrench. part #5462.
  • Page 29: Tq I Advanced Tuning Guide

    (set to The Multi-Function knob can be set to control Throttle Sensitivity. Starting Over: Traxxas Stability Management (TSM) by default, see page 16). Accessing Throttle Sensitivity works the same way as Steering Sensitivity, as Restoring Factory Defaults the programming menu is done by using the menu and set buttons on described on page 16, but applies the effect to the throttle channel.
  • Page 30 This is especially handy if you operate multiple vehicles equipped with a built-in failsafe This allows you to fine-tune the servo settings to prevent binding with a single transmitter via Traxxas Link ™ Model Memory. function that returns the throttle...
  • Page 31 2. Press and hold MENU. Release when the status LED blinks green. in your collection and simply turn them on and drive. With Traxxas Link 3. Press MENU three times. The status LED will blink green four Model Memory, there is no need to remember which transmitter goes times repeatedly.
  • Page 32 Transmitter is restored to default Press 32 • SUMMIT C onfirm Deletion Delete Model Two Blinks Green One Blink Red *Torque Control is a feature designed only for use with the power system in the Traxxas Funny Car Race Replica (Model #6907).
  • Page 33 Press/hold MENU Press MENU Press SET Press MENU twice Press SET Press SET to reverse Press/hold MENU SUMMIT • 33 servo green LED blinks green LED blinks (x2) green LED blinks green LED blinks (x3) red LED blinks servo direction...
  • Page 34 Traxxas Link For more information Real-Time Telemetry The powerful Traxxas Link app (available in the Apple App Store℠ or on about the Traxxas Link When you equip your model Google Play™) gives you complete control over the operation and tuning...
  • Page 35 ’ MODEL 56076-4 6250 Traxxas Way McKinney, Texas 75070 1-888-TRAXXAS 200512 56076-4-OM-N-EN-R05...

This manual is also suitable for:

56076-4Summit 56076-4

Table of Contents

Save PDF