NordicTrack E 9.5 User Manual page 9

6. Identify the Right Pedal (14), the Right Pedal
Insert (117), and the Right Pedal Arm (12) and
orient them as shown.
Attach the Right Pedal (14) and the Right Pedal
Insert (117) to the Right Pedal Plate (80) with
four M6 x 12mm Screws (146). Tip: It may be
helpful to lift the Right Pedal Plate.
Attach the Left Pedal (not shown) and the
Left Pedal Insert (not shown) to the Left
Pedal Plate (not shown) in the same way.
7. Apply grease to the axle on the right Crank
Arm (39).
Orient a Pedal Arm Sleeve (46) so that the flat
side is facing the elliptical. Slide the Pedal Arm
Sleeve onto the axle on the right Crank Arm (39).
Attach the Pedal Arm Sleeve (46) with an M8 x
25mm Screw (121), a Large Axle Cover (113),
and an M8 Washer (95). Tip: Avoid damaging
the Large Axle Cover when tightening the
Screw.
Repeat this step on the other side of the
elliptical.
6
117
80
12
7
9
14
146
Grease
39
46
95
113
Flat
Side
121