NordicTrack E 9.5 User Manual page 7

2. Orient the Front Stabilizer (3) so that the indi-
cated hole is facing the pin on the Main
Frame (1).
While a second person lifts the front of the Main
Frame (1), attach the Front Stabilizer (3) with
two M10 x 95mm Screws (100).
3. Orient the Upright (5) and the Top Cover (27) as
shown.
Slide the Top Cover (27) upward onto the
Upright (5).
Then, have a second person hold the Upright (5)
and the Top Cover (27) near the Main Frame (1).
Locate the wire tie in the Upright (5). Tie the
lower end of the wire tie to the Main Wire (60).
Next, pull the upper end of the wire tie until the
Main Wire is routed through the Upright.
Tip: To prevent the Main Wire (60) from fall-
ing into the Upright (5), secure the Main Wire
with the wire tie.
2
3
Wire Tie
5
27
Wire Tie
60
7
100
3
Hole
Pin
1
1