NordicTrack E 9.5 User Manual page 8

4. Tip: Avoid pinching the Main Wire (60). Insert
the Upright (5) into the Main Frame (1).
Attach the Upright (5) with four M8 x 16mm
Screws (102) and four M8 Split Washers (103);
do not tighten the Screws yet. You will
tighten the Screws at the end of step 11.
5. Using a small plastic bag to keep your fingers
clean, apply a coat of the included grease to the
Upright Axle (48) and to two Wave
Washers (118).
Insert the Upright Axle (48) through the Upright
(5) and center it. Then, slide a Wave Washer
(118) onto each side of the Upright Axle.
Next, identify the Right and Left Upper Body
Legs (6, 7) and orient them as shown.
Slide the Right and Left Upper Body Legs (6, 7)
onto the Upright Axle (48).
Then, tighten an M8 x 16mm Screw (102) and
an M8 Washer (95) into each end of the Upright
Axle (48) at the same time.
4
5
103
102
5
102
95
118
7
Grease
8
Avoid pinching the
Main Wire (60)
102
103
1
102
103
102
5
48
118
95
102
6