Installation Test Checklist - Bosch Rexroth CS550 Installation Manual

10

Installation Test Checklist

Work order #:
Part number:
Serial number:
After all controller cables and hydraulics are plumbed – vehicle hopper empty
OK
Start the vehicle – engage hydraulic pump
Power on display, check for backlight and display operation
Press the "speed" field and hold the "up arrow" for 5 seconds – Release (Turning on
simulated ground speed)
Press the up arrow again to increase speed to 20
Rotate all the dials clockwise to 5 – rate should change
Verify that the conveyor/auger is operating – feedback?
Verify that the spinner is operating
Verify that the liquid pump is operating – feedback?
Verify that the gate cylinder and sensor is operating
(if equipped)
Press the speed down arrow to lower the speed to 0 –
press the speed field to exit
Drive the vehicle to check that vehicle speed registers
Activate the joystick as defined in the OSD test drawing –
verify proper actuation
Test special functions – power float, low oil, emergency raise
Test auxiliary switches for proper operation
The above procedure is a simple way to verify system connections,
hydraulics operation, and sensor feedback. It may not work for all the
systems. The reliable way to test is to follow the steps in 550
Calibration Manual.
Date:
Software Version:
Signature:
Bosch Rexroth Canada ı May 2019 ı Revision 5.0
18/20
NOTES