LevelOne FCS-5051 User Manual page 50

Pre-trigger buffer recording function allows users to check what happened to cause the
trigger. The pre-trigger buffer time range is from 1 to 3 seconds.
Select <Upload for __ sec> to set the recording duration after alarm is triggered. The
setting range is from 1 to 99999 seconds.
Select <Upload during the trigger active> to record the triggered video until the trigger is
off.
NOTE: Please make sure the local recording (with Micro SD/SDHC card)
is activated so that this function can be implemented. Refer to Recording
for further details.
File Name
Enter a file name in the blank, ex. image.jpg. The uploaded image's file name format can be
set in this section. Please select the one that meets your requirements.
 Add date/time suffix
File name: imageYYMMDD_HHNNSS_XX.jpg
Y: Year, M: Month, D: Day
H: Hour, N: Minute, S: Second
X: Sequence Number
 Add sequence number suffix (no maximum value)
File name: imageXXXXXXX.jpg
X: Sequence Number
 Add sequence number suffix up to # and then start over
File Name: imageXX.jpg
X: Sequence Number
The file name suffix will end at the number being set. For example, if the setting is up to
"10," the file name will start from 00, end at 10, and then start all over again.
 Overwrite
The original image in the FTP site will be overwritten by the new uploaded file with a
static filename.
49