LevelOne FCS-5051 User Manual page 49

trigger active until the alarm is released. Set the Image frequency as the upload frame
rate. The setting range is from 1 frame to 15 frames.
NOTE: Make sure FTP configuration has been completed. Refer to FTP
for further details.
 Upload Image by E-Mail
Select this item and the Administrator can assign an e-mail address and configure
various parameters. When the alarm input is triggered, event images will be sent to the
appointed e-mail address.
<Pre-trigger buffer> function allows users to check what happened to cause the trigger.
The <Pre-trigger buffer> frame rate could be pre-determined.
On the other hand, <Post-trigger buffer> is for users to upload certain amount of images
after alarm input is triggered. Check the box <Continue image upload> to upload the
triggered images during certain time or keep uploading until the trigger is off. Select
<Upload for __sec> and enter the duration in the blank. The images of the duration will
be uploading by E-mail when the alarm input is triggered. The setting range is from 1 to
9999 seconds. Select <Upload during the trigger active> to make the images keep
being uploaded to E-mail during the trigger active until the alarm is released. Set the
Image frequency as the upload frame rate. The setting range is from 1 frame to 15
frames.
NOTE: Make sure SMTP configuration has been completed. Refer to Mail
for further details.
 Send HTTP notification
Check this item, select the destination HTTP address, and specify the parameters for
event notifications by <Alarm> triggered. When an alarm is triggered, the notification
can be sent to the specified HTTP server.
For instance, if the custom parameter is set as" action=1&group=2", and the HTTP
server name is" http://192.168.0.1/admin.php", the notification will be sent to HTTP
server as" http://192.168.0.1/admin.php?action=1&group=2" when alarm is triggered.
 Record Stream to SD Card
Select the item and the alarm-triggered recording will be saved into your Micro SD card.
48