LevelOne FCS-5051 User Manual page 48

Alarm Output
Define alarm output signal <high> or <low> as the normal alarm output status according to
the current alarm application.
Triggered Action (Multi-option)
The Administrator can specify alarm actions that will take when the alarm is triggered. All
options are listed as follows:
 Enable Alarm Output
Select the item to enable alarm relay output.
 IR Cut Filter
Select the item and the camera's IR cut filter (ICR) will be removed (on) or blocked (off)
when alarm input is triggered.
 Send Message by FTP/E-Mail
The Administrator can select whether to send an alarm message by FTP and/or E-Mail
when an alarm is triggered.
 Upload Image by FTP
Select this item and the Administrator can assign a FTP site and configure various
parameters. When the alarm is triggered, event images will be uploaded to the
appointed FTP site.
<Pre-trigger buffer> function allows users to check what happened to cause the trigger.
The <Pre-trigger buffer> frame rate could be pre-determined.
On the other hand, <Post-trigger buffer> is for users to upload certain amount of images
after the alarm input is triggered.
Check the box <Continue image upload> to upload the triggered images during certain
time or keep uploading until the trigger is off. Select <Upload for __sec> and enter the
duration in the blank. The images of the duration will be uploaded to FTP when the
alarm input is triggered. The setting range is from 1 to 9999 seconds. Select <Upload
during the trigger active> to make the images keep being uploaded to FTP during the
Note: The IR Function (Refer to IR Function) could not be set as <Auto>
mode if this triggered action is enabled.
47