Setting A Channel Or Id Of Transmitter And Wireless Speaker - LG KR-W1080HTS Manual

Setting a channel or ID of
transmitter and wireless speaker
Note:
If there is a strong electromagnetic wave product
nearby, an interference may be occurred. Put the unti
(wireless speaker and main unit) away from there.
(Ex : Micro wave oven)
Transmitter
SIGNAL ID./CH. DC IN
Setting a channel of Transmitter
If there is a similar wireless product nearby, interference
may occur. In this case, change to other channel using
ID/CHANNEL (ID./CH.) button of transmitter.
Press the ID/CHANNEL (ID./CH.) button for less
than about 3 seconds.
If the wireless TX and wireless speakers signals do not
match after operating as above, operate it again about
three times.
Note:
The wireless speakers may not receive the changed channel of
transmitter (The blue LED of Wireless TX will flicker. The LED
of Wireless speakers will turn red or the blue LED of Wireless
speakers will flicker). In this case set the ID as next paragraph.
10
Initial setting an ID of Transmitter
1. Connect the SOUND SIGNAL connector of
2. Connect the DC IN connector of transmitter and the
3. Connect power cord of each wireless speakers to
4. Turn the main unit ON.
LED indicator
Displays the operated
status.
Setting an ID of Transmitter
If an interference is occurred or you use a new
wireless speaker, set the ID.
DC IN connector 1. Disconnect power cord of wireless speakers.
2. Press the ID/CHANNEL (ID./CH.) button for more
ID/CHANNEL (ID./CH.)
button
SOUND SIGNAL
3. Connect power cord of wireless speakers.
connector
Note:
If there is no audio signal for longer than 10 minutes, the
wireless speakers and transmitter will be automatically
switched to power saving mode. At power saving mode,
both LEDs will turn red. LEDs will turn blue when there is
any audio signal back.
If you operate main unit then wireless speakers (rear
speakers) sound within a few seconds in standby mode.
transmitter and the rear (right, left) speaker terminals
of main unit with the SOUND SIGNAL cable.
transmitter connector of main unit with the DC power
cable.
the wall power outlet.
Blue LEDs of transmitter will flicker and Blue and Red
LEDs of wireless speakers will flicker in turn, then the
Blue LEDs of both transmitter and
will stay on when the wireless system works normally.
than about 3 seconds.
The blue LED indicator
will quickly flicker
wireless
speakers
.