Setting An Id Of Transmitter - LG HT502THW-A3 Owner's Manual

Setting an ID of Wireless
Transmitter
When the unit is manufactured, the ID is already set.
If an interference occurs or you use a new Wireless
RX, an ID is set again.
1. Connect the SOUND SIGNAL connector of
transmitter and the rear (right, left) speaker
terminals of main unit with the SOUND SIGNAL
cable.
2. Connect the DC IN connector of Wireless
Transmitter and the Wireless Transmitter connector
of main unit with the DC power cable.
3. Disconnect power cord of Wireless Receiver.
4. Press the ID. button for more than about 3
seconds.
The blue LED indicator
will quickly flicker
5. Connect power cord of Wireless Receiver.
Rear speaker (Wireless speakers) is no sound.
The DC power cable is not connected the Wireless Transmitter and main unit.
Connect the Wireless Transmitter and main unit with the DC power cable.
Power cord of Wireless Receiver (or Wireless speakers) is not connected.
Connect the Power cord of Wireless Receiver (or Wireless speakers).
LED indicator of Wireless Transmitter is RED.
- Turn on the main unit.
- Set to sound mode by PL ll MOVIE, PL ll MUSIC or PL ll MTRX. (page 22)
- Set to XTS-ON. (page 22)
- Insert a 5.1 ch sound compatible disc.
If rear speaker (Wireless speakers) is no sound after operating as above, disconnect
and connect the power cord of
of Wireless Transmitter and Wireless
Note:
If there is no audio signal for longer than 10 minutes,
the Wireless Receiver and Wireless Transmitter will
be automatically switched to standby mode. At power
saving mode, both LEDs will turn red. LEDs will turn
blue when there is any audio signal back.
If you operate main unit then wireless speakers (rear
speakers) sound within a few seconds in standby
mode.
.
CAUTION
(or Wireless speakers) or set up an ID
Wireless Receiver
(or Wireless speakers).
Receiver
11