Setting An Id Of Wireless Transmitter - LG HT353SDW Manual

Wireless Receiver
LED indicator of Wireless Receiver
* LED indicator - "BLUE"
The Wireless Receiver is receiving a signal of wireless
transmitter.
* LED indicator - "RED"
The Wireless Receiver is in standby mode.
Rear speaker connector
Power switch (ON/OFF)
Power cord
Rear speaker (Wireless speakers) is no sound.
The DC power cable is not connected the Wireless Transmitter and main unit.
Connect the Wireless Transmitter and main unit with the DC power cable.
Power cord of Wireless Receiver (or Wireless speakers) is not connected.
Connect the Power cord of Wireless Receiver (or Wireless speakers).
LED indicator of Wireless Transmitter is RED.
- Turn on the main unit.
- Set to sound mode by PL ll MOVIE, PL ll MUSIC or PL ll MTRX. (page 9)
- Insert a 5.1 ch sound compatible disc.
If rear speaker (Wireless speakers) is no sound after operating as above, disconnect
and connect the power cord of
of Wireless Transmitter and Wireless

Setting an ID of Wireless Transmitter

When the unit is manufactured, the ID is already set.
If an interference occurs or you use a new Wireless RX, an ID is
LED indicator
set again.
Displays the operated
1. Connect the SOUND SIGNAL connector of transmitter and
status.
2. Connect the DC IN connector of Wireless Transmitter and the
3. Turn off the Wireless Receiver.
4. Press the ID. button for more than about 3 seconds.
5. Turn on the Wireless Receiver.
Note:
If there is no audio signal for longer than 10 minutes, the
Wireless Receiver and Wireless Transmitter will be automatically
switched to standby mode. At power saving mode, both LEDs
will turn red. LEDs will turn blue when there is any audio signal
back.
If you operate main unit then wireless speakers (rear speakers)
sound within a few seconds in standby mode.
CAUTION
Wireless Receiver
Receiver
the rear (right, left) speaker terminals of main unit with the
SOUND SIGNAL cable.
Wireless Transmitter connector of main unit with the DC
power cable.
The blue LED indicator will quickly flicker.
(or Wireless speakers) or set up an ID
(or Wireless speakers).
7