Depth Adjustment - Porter-Cable TS056 Instruction Manual

FN250SB-BN200SB_9R198001RA_PC_16GA and 18GA FINISH NAILER MANUAL_MAN_JM3_107674RevE_Manua
Always disconnect air supply: 1. Before making adjustments; 2. When
servicing the tool; 3. When clearing a jam; 4. When tool is not in use;
5. When moving to a different work area, as accidental actuation may
occur, possibly causing injury.
BN200SB AND FN250SB FASTENER CONTROL ADJUSTMENT
The Fastener Control adjustment feature provides close control of the fastener drive depth;
from flush with the work surface to shallow or deep countersink. First, set the air pressure
for consistent drive in the specific work. Then use the Fastener Control adjustment to give
the desired depth of drive.
TO ADJUST FASTENER CONTROL ADJUSTMENT:
1. With air pressure set, drive a few fasteners into a representative material sample to
determine if adjustment is necessary.
2. If adjustment is required, disconnect air supply.

DEPTH ADJUSTMENT

DEPTH ADJUSTMENT
FN25 SB
BN2 SB
-10-
Depth Adjustment Knob
Depth Adjustment Knob