Sanyo PLC-XU300A Owner's Manual page 42

Video Input
Sharpness
7
Press the Point button to decrease the sharpness of the
image; press the Point
of the image (from 0 to 15).
Gamma
7 8
Use the Point buttons to adjust the gamma value to
obtain a better balance of contrast (from 0 to 15).
Noise reduction
Noise interference on the screen can be reduced. Select
one of the following options to get smoother images.
Off . ......... Disabled.
L1 .......... Lower reduction
L2 .......... Higher reduction
Progressive
An interlaced video signal can be displayed in progressive
mode. Select one of the following options.
Off . ......... Disabled.
L1 .......... For an active picture.
L2 .......... For a still picture.
Film . ....... For watching a film. With this function, the
projector reproduces pictures faithful to the
original film quality.
Reset
To reset the adjusted data, select Reset and press the
SELECT button. A confirmation box appears and then select
yes. All adjustments will return to their previous figures.
Store
To store the adjusted data, select Store and press the Point
8
button or the SELECT button. Use the Point
to select one from Image 1 to 4 and press the SELECT
button.
A confirmation box appears and then select yes. Stored
data can be called up by selecting an Image (1–4) in the
Image Mode Selection on page 40.
✔ Note:
Noise reduction and Progressive cannot be selected
when 480p, 575p, 70p, 1035i, or 1080i is selected
(p.39).
4
8
button to increase the sharpness
ed
Store Menu
buttons
A confirmation box
appears and then
select yes .