Video Input; Input Source Selection (Video, S-Video) - Sanyo PLC-XU300A Owner's Manual

Video Input

Input Source Selection (Video, S-video)

Direct Operation
Choose Video or S-video by pressing the INPUT button on
the top control, or the VIDEO button or the S-VIDEO button
on the remote control.
Before using INPUT button, correct input source should be
selected through menu operation as described below.
Menu Operation
1 Press the MENU button to display the On-Screen
Menu. Use the Point
then press the Point
 ed
Use the Point
S-video and then press the SELECT button.
When video input signal is connected to the
Video
VIDEO jack, select Video.
When video input signal is connected to the S-
S-video
VIDEO jack, select S-video.
✔ Note:
When the Input Search function is set to On1 or On in
the Auto setup function, the input signal will be searched
automatically (p.45).
ed
buttons to select Input and
8 or
the SELECT button.
buttons to select either Video or
INPUT button
Top Control
(Component) / (RGB(Scart))
Remote Control
VIDEO button
S-VIDEO button
Input Menu
Computer 1(RGB) /
Computer (RGB)
Video
S-video
Video
S-video
37