Screen Size Adjustment - Sanyo PLC-XU300A Owner's Manual

Store
To store the adjusted data, select Store and press the Point
8
button or the SELECT button. Use the Point
to select one from Image 1 to 4 and press the SELECT
button.
A confirmation box appears and then select yes. Stored
data can be called up by selecting an Image (1–4) in the
Image Mode Selection on page 33.

Screen Size Adjustment

This projector has the picture screen resize function, which
enables you to customize the image size.
1 Press the MENU button to display the On-Screen
Menu. Use the Point
8 or the SELECT
then press the Point
ed
 Use the Point buttons select the desired item and
then press the SELECT button .
Normal
Provide the image to fit the screen size.
True
Provide the image in its original size. When the original
image size is larger or smaller than the screen size (1024 x
768), the projector enters to the panning mode automatically.
7 8
ed
Use the Point buttons to pan the image if it's larger
than the screen size. When adjusted, the arrows will turn
red. When reached to the correction limits, the arrows will
disappear.
wide
Provide the image to fit the wide video aspect ratio (16:9) by
expanding the image width uniformly. This function can be
used for providing a squeezed video signal at 16:9.
Full
Provide the full screen image.
✔ Note:
• The Screen Menu, except for Normal and Custom, cannot be operated when 70p(HDTV), 1035i (HDTV),
or 1080i (HDTV) is selected in the PC System Menu (p.29).
• This projector cannot display any resolution higher than 1920 x 1200. If your computer's screen resolution is
higher than it, reset the resolution to the lower before connecting to the projector.
• The image data in other than 1024 x 768 is modified to fit the screen size in initial mode.
• True, Full, and Digital zoom +/– cannot be selected when 480i, 575i, 480p, or 575p is selected in the PC
System Menu (p.29).
ed
buttons
ed
buttons to select Screen and
button.
A confirmation box appears and
then select yes .
Screen Menu
Computer Input
35