AEG BEB231011M User Manual page 19

Step 3 Close the oven door halfway to the
first opening position. Then lift and
pull forward and remove the door
from its seat.
Step 4 Put the door on a soft cloth on a
stable surface.
Step 5 Hold the door trim (B) on the top
edge of the door at the two sides
and push inwards to release the
clip seal.
Step 6 Pull the door trim to the front to re‐
move it.
Step 7 Hold the door glass panel by its top
edge and carefully pull it out. Make
sure the glass slides out of the
supports completely.
Step 8 Clean the glass panels with water
and soap. Dry the glass panels
carefully. Do not clean the glass
panels in the dishwasher.
Step 9 After cleaning, install the glass
panel and the oven door.
The screen-printing zone must face the in‐
ner side of the door. Make sure that after
the installation the surface of the glass
panel frame on the screen-printing zones
is not rough when you touch it.
When installed correctly the door trim
clicks.
Make sure that you install the internal
glass panel in the seats correctly.
2
B
ENGLISH 19
1
A
B