Fan Alignment And Hanger Bracket Installation - Fanimation Palisade FP240 Series Owner's Manual

Assembling Crossbar To The Extension Pole (cont'd)
¼˝ x 2 ⁄ ˝ socket head bolts and locking nuts. Securely
3
16
tighten both bolt and nut sets (Figure 2).
5. Slide Canopy over onto Extension Pole.
6. Route wires and safety cable though the Hanger Ball
Adapter Assembly. (Figure 3)
7. Assemble the Hanger Ball Adapter Assembly to top of
the Extension Pole with the 4 screws supplied with the
fan. (Figure 3)
8. The fan comes with blue, black and white leads. Before
installing fan, measure up approximately 6-9 inches
above the top of the hanger adapter. Cut off excess wire
and strip back insulation ½˝ from end of wire.
INSTALLATION NOTE
Do not connect fan blades until the fan is completely
installed. Hanging the fan with blades connected may
result in damage to the fan blades.
▲WARNING
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades or
cleaning the fan. Do not insert foreign objects in between
the rotating blades.

Fan Alignment And Hanger Bracket Installation

▲WARNING
Failure to follow these Hanger Bracket installation
procedures may result in damage to Hanger
Bracket.
1. Attaching Ceiling Support Cable (Figure 1): Drill ¼˝
pilot hole through one of the four corners of the junction
box, into the ceiling joist or structural member. Securely
attach the ceiling support cable with
fl at washer.
NOTE: Ceiling support cable must be fastened between
fl at washer and junction box with 2˝ lag bolt (Figure 1).
2. Preliminary Hanger Bracket Attachment (Figure 1):
Drill ¼˝ pilot hole through the center of the junction
box, into the ceiling joist or structural member. Loosely
attach hanger bracket to the ceiling structure using
5˝ lag bolt and fl at washer. DO NOT FULLY TIGHTEN
THE LAG BOLT YET! Hanger Bracket should be free to
rotate.
⁄ ˝ x 2˝ lag bolt and
3
8
⁄ ˝ x
3
8
5
Figure 3
This Lag Bolt is NOT
fully fastened
Figure 1
Pin
Setscrew
Hanger Ball
Adapter
Assembly
Extension
Pole
Screw (4)
This Lag Bolt is
fastened securely
Hanger
Bracket is
loose and
free to rotate