Do you have a question about the Super Washer and is the answer not in the manual?
Questions and answers
Ron Proper
April 29, 2025
Does the equator washer need special water hoses?
1 comments:
Mr. Anderson
May 15, 2025
No, the Equator washer does not require special water hoses. It uses standard water inlet hoses.
This answer is automatically generated
David Kossak
January 31, 2025
Suddenly, my washer, which is a super washer equator started to flash a message E8 I had not even turned it on. It will not open, and I do not know how to reset.
1 comments:
Mr. Anderson
May 14, 2025
The E8 error message on an Equator Super Combo 4400 washer typically indicates a problem with the door sensor. If the door is shut but the error still appears, it may be due to a faulty door lock or a faulty computer control.
To try resetting the system: 1. Unplug the washer for five minutes, then plug it back in. 2. Press and hold the Cancel or Stop button for three seconds. 3. If that doesn’t work, press and hold the Power button for three seconds. 4. There may also be a special sequence of buttons to reset the unit.
If the error persists, the door lock or the control board may need to be replaced.
Need help?
Do you have a question about the Super Washer and is the answer not in the manual?
Questions and answers
Does the equator washer need special water hoses?
No, the Equator washer does not require special water hoses. It uses standard water inlet hoses.
This answer is automatically generated
Suddenly, my washer, which is a super washer equator started to flash a message E8 I had not even turned it on. It will not open, and I do not know how to reset.
The E8 error message on an Equator Super Combo 4400 washer typically indicates a problem with the door sensor. If the door is shut but the error still appears, it may be due to a faulty door lock or a faulty computer control.
To try resetting the system:
1. Unplug the washer for five minutes, then plug it back in.
2. Press and hold the Cancel or Stop button for three seconds.
3. If that doesn’t work, press and hold the Power button for three seconds.
4. There may also be a special sequence of buttons to reset the unit.
If the error persists, the door lock or the control board may need to be replaced.
This answer is automatically generated