Safety Distance; General Safety Information - Image Engineering iQ-Near Focus User Manual

1.3.3 Safety distance

To ensure user safety, keep a safe distance of approx. 1m from the unit during operation. To
facilitate this, the iQ-Near Focus comes with a wired remote control that connects to the control
box.
Emergency STOP switch
Of course, this distance cannot be maintained while using the control unit (located below chart
housing) to make adjustments. In the process, make sure that no part of your body, clothing or
hair protrudes into the chart opening or the safety cover.
Attention! In the event of an accident, the device must be stopped immediately with the use of
the emergency stop switch, which is located right next to the control unit. Push it to stop the
motor instantly.

1.3.4 General safety information

Do not open the device without any instructions from the Image Engineering support team or
when connected to a power supply.
Image Engineering
Introduction
Figure 1: Safety distance during operation
iQ-Near Focus
Seite 4 von 11