Beko 674532MI User Manual page 37

Do not connect the product to
supply systems such as solar power
supplies. Otherwise, damage to
your product may occur as a result
of the abrupt voltage fluctuations!
The more refrigerant a refrigerator
contains, the bigger its installation
room shall be. In very small rooms,
a flammable gas-air mixture may
occur in case of a gas leak in the
cooling system. At least 1 m3 of
volume is required for each 8
grams of refrigerant. The amount
of the refrigerant available in your
product is specified in the Type
Label.
The installation place of the
product shall not be exposed to
direct sunlight and it shall not be in
the vicinity of a heat source such as
stoves, radiators, etc.
If you cannot prevent installation of the
product in the vicinity of a heat source, you
shall use a suitable insulation plate and
the minimum distance to the heat source
shall be as specified below.
- At least 30 cm away from heat
sources such as stoves, heating units and
heaters, etc.,
- And at least 5 cm away from electric
ovens.
Your product has the protection
class of I. Plug the product in a
grounded socket that conforms
with the Voltage, Current and
Frequency values specified in the
type label. The socket outlet shall
be equipped with a fuse with a
rating of 10 A – 16 A. Our company
shall not be responsible for the
damages that shall be incurred as
a result of operating the product
without ensuring ground and
electrical connections made as per
local or national regulations.
The product's power cable must
be unplugged during installation.
Otherwise, risk of electric shock
and injury may occur!
Do not plug the product to loose, bro-
ken, dirty, greasy sockets or sockets
that has come out their seats or soc-
kets with a risk of water contact.
Place the power cord and hoses (if ava-
ilable) of the product so that they shall
not cause a risk of tripping over.
Penetration of humidity to live parts
or to the power cord may cause short
circuit. Thus, do not use the product in
humid environments or in areas where
water may splash (e.g. garage, laundry
room, etc.) If the refrigerator is wet by
water, unplug it and contact an autho-
rized service.
Do not connect your refrigerator to po-
wer saving devices. These systems are
harmful for the product.
1.6 Operational safety
Do not use chemical solvents on the
product. These materials contain an
explosion risk.
In case of a failure of the product, unp-
lug it and do not operate until it is re-
paired by the authorized service. There
is a risk of electric shock!
Do not place a source of flame (e.g.
candles, cigarettes, etc.) on the pro-
duct or in the vicinity of it.
Do not get on the product. Risk of fal-
ling and injury!
Do not cause damage to the pipes of
the cooling system using sharp and pi-
ercing tools. The refrigerant that sprays
out in case of puncturing the gas pipes,
pipe extensions or upper surface coa-
tings may cause irritation of skin and
injuries of the eyes.
Do not place and operate electric app-
liances inside the refrigerators/deep
freezer unless it is advised by the ma-
nufacturer.
5
EN