Front Wheel - Baby Jogger city select 2 Assembly Instructions Manual

FRAME
1 Unpack the stroller frame from the box
and set the wheels aside. Unlock the
stroller by pulling the storage lock lever.
2 Lift the handlebar away from the lower
frame. The stroller will click into place.
3 Place the stroller in the upright position.
WARNING: Ensure that all the locking
devices are engaged before use.

FRONT WHEEL

4 Installation
• Lay stroller on its back so the
handlebar is resting on the floor.
• Attach the front wheel by sliding it into
the front wheel mount until it clicks.
Gently pull on the front wheel to make
sure it is properly attached.
5 Removal
• While pressing the front wheel release
button, gently slide the front wheel out
of the front wheel mount.
REAR WHEELS
6 Installation
• Align the rear wheel axle with the
wheel mount on the stroller frame and
insert it into the wheel mount until it
clicks into place.
• Gently pull on the rear wheel to make
sure it is properly attached.
7 Removal
• While pressing the wheel release
button, gently slide the rear wheel out
of the wheel mount.
BRAKE
8 To lock the brakes: push the brake lever
down to engage the brakes.
9 To release the brakes: lift the brake lever
up.
WARNING: Lock the brakes before
loading and unloading your child and
whenever the stroller is not moving.
SEAT
10 Insert the footwell bar into the footwell
adjustment mounts on the lower portion
of the seat frame.
Press buttons on outside of foot bar and
slide the foot bar into the bracket until it
clicks into place.
11 From the back of the seat, fasten snaps
to seat frame.
12 From the back of the seat, fasten
the hook-and-loop by slide the strap
through the D-ring.
CANOPY
13 Attach the canopy to the seat frame:
Attach the canopy' s brackets to the
sides of the seat frame.
NOTE: canopy position can be adjusted
up and down the seat frame tube.
14 Attach the 3 fastening strips on the
canopy to the top of the seat.
15. Ensure that canopy mesh is covering
the seat back.
ATTACHING BELLY BAR (on certain
models)
16 Attach belly bar mount over RIGHT
seat mount by pushing seat mount
button in and sliding belly bar mount
over seat mount.
17 Push belly bar mount toward seat
frame until it clicks into frame and
behind seat mount button.
18 Attach belly bar over LEFT seat mount
by pushing seat mount button in and
sliding belly bar over seat mount until it
secures to frame.
19 Push belly bar toward seat frame until
it clicks into frame and behind seat
mount button.
20 To secure, rotate belly bar down to
connect to belly bar mount.
21 To open belly bar, (a) slide button
release on top of belly bar end, then
(b) press the button on bottom of belly
bar and (c) rotate up from mount.
ADJUSTING SAFETY HARNESS
22 From the back of the seat, undo the
fastening strip and open the pocket to
locate the plastic square stopper. Turn
stopper and pass through the openings
in the PE board and seat fabric.
23 Reinsert stopper at seat opening closest
to child' s shoulders. Pass back through
seat fabric and PE board. Tug on strap
to ensure stopper is locked. Repeat on
both sides.
WARNING: Avoid serious injury from
falling or sliding out. Always properly
adjust and fasten safety harness.
WARNING: Always use the crotch strap
in combination with the shoulder straps
13
and waist belt.
EN