Front Wheel - Baby Jogger City Mini GT2 Assembly Instructions Manual

FRAME
EN
1 Unpack the stroller frame from the
box and set the wheels aside.
Unlock the stroller by pulling the
storage lock Lever.
2 Unfold the stroller by pulling the
handlebar away from the frame
stroller will lock into place and you will
hear a click.
3 Place the stroller in the upright
position.
WARNING: Ensure that all the locking
devices are engaged before use.

FRONT WHEEL

4 Installation
• Lay stroller on its back so the
handlebar is resting on the floor
• Attach the Front Wheel by sliding it
into the front wheel mount until it
clicks Gently pull on the Front Wheel
.
to make sure it is properly attached
5 Removal
• While pressing the front wheel
release button, gently slide the Front
Wheel out of the front wheel mount
SWIVEL FEATURE
6 Push the swivel button down and
rotate to the left to lock the front
wheel assembly in a fixed position for
long distance strolling
7 Push the swivel button down and
rotate to the right to allow the front
wheel assembly to swivel
WARNING: When loading and
unloading child, lock the front wheel
in a fixed position
wheel of your stroller locks, it is not
intended for jogging or exercise
purposes
.
REAR WHEELS
8 Installation
• Align the rear wheel axle with the
wheel mount on the stroller frame
and insert it into the wheel mount
until it locks into place. You will hear
a click.
The
.
.
.
.
.
.
Although the front
.
• Gently pull on the rear wheel to
make sure it is properly attached.
9 Removal
• While pressing down on the wheel
release button, gently slide the rear
wheel out of the wheel mount.
BRAKE
10
To Lock the Brakes: gently pull the Brake
Lever into upright position until it clicks
into place.
11
To Release the Brakes: Pinch the gray tabs
and pull the lever towards you. Push the
Brake Lever down until it is parallel with
the frame.
WARNING: Lock the brakes before
loading and unloading your child and
whenever the stroller is not moving.
CANOPY
12 Attach the canopy to the frame by
sliding the canopy onto one of two
mounting brackets
canopy off of mounts
NOTE: When using a City Go/
Graco or Britax car seat, the
canopy must be in the top
position For all other carseats,
.
canopy must be removed
13 Snap the two snaps to the stroller
frame
.
14 Zip the back of the seat to the canopy
top
.
Attach the 2 fastening strips on the
side of the canopy
15 Pull forward to open canopy and push
backwards to close canopy
16 There are two canopy windows, a top
one and back one
the shade up towards the top and
secure with the elastic and button
HANDLE
17 To change the handle to one of 6 use
positions, press the handle release
buttons on both sides and rotate up or
down to the new position.
12
To remove, slide
.
.
.
.
.
To use them, roll
.
.