DeWalt D21583 Original Instructions Manual page 34

EN GLI SH
The vibration emission level given in this information
sheet has been measured in accordance with a
standardised test given in EN 60745 and may be
used to compare one tool with another. It may be
used for a preliminary assessment of exposure.
WARNING: The declared vibration
emission level represents the main
applications of the tool. However if the
tool is used for different applications,
with different accessories or poorly
maintained, the vibration emission may
differ. This may significantly increase the
exposure level over the total working
period.
An estimation of the level of exposure to
vibration should also take into account
the times when the tool is switched off
or when it is running but not actually
doing the job. This may significantly
reduce the exposure level over the total
working period.
WARNING: Identify additional safety
measures to protect the operator from
the effects of vibration such as: maintain
the tool and the accessories, keep
the hands warm, organisation of work
patterns.
Fuses:
Europe 230 V tools
U.K. & Ireland 230 V tools
U.K. & Ireland 115 V tools
NOTE: This device is intended for the connection to
a power supply system with maximum permissible
system impedance Zmax of 0.25Ω at the interface
point (power service box) of user's supply.
The user has to ensure that this device is connected
only to a power system which fulfils the requirement
above. If necessary, the user can ask the public
power supply company for the system impedcance
at the interface point.
Defi nitions: Safety Guidelines
The definitions below describe the level of severity
for each signal word. Please read the manual and
pay attention to these symbols.
DANGER: Indicates an imminently
hazardous situation which, if not avoided,
will result in death or serious injury.
WARNING: Indicates a potentially
hazardous situation which, if not
avoided, could result in death or
serious injury.
32
EC-Declaration of Conformity
MACHINERY DIRECTIVE
D21583
D WALT declares that these products described
E
under "technical data" are in compliance with:
2006/42/EC, EN 60745-1, EN 60745-2-1.
(Stationary use:) EN 61029-1, EN 61029-2-6.
These products also comply with Directive
2004/108/EC. For more information, please contact
D WALT at the following address or refer to the
E
back of the manual.
10 Amperes, mains
The undersigned is responsible for compilation of the
13 Amperes, in plugs
technical file and makes this declaration on behalf of
16 Amperes, mains
D WALT.
E
Horst Grossmann
Vice President Engineering and Product
Development
D WALT, Richard-Klinger-Straße 11,
E
D-65510, Idstein, Germany
01.01.2010
General Power Tool Safety Warnings
CAUTION: Indicates a potentially
hazardous situation which, if not
avoided, may result in minor or
moderate injury.
NOTICE: Indicates a practice not
related to personal injury which, if
not avoided, may result in property
damage.
Denotes risk of electric shock.
Denotes risk of fire.
WARNING: To reduce the risk of injury,
read the instruction manual.
WARNING! Read all safety warnings
and instructions Failure to follow the
warnings and instructions may result in
electric shock, fire and/or serious injury.