DeWalt D21520-XE Instruction Manual
  1. Manuals
  2. Brands
  3. DeWalt Manuals
  4. Drill
  5. D21520-XE
  6. Instruction manual
DeWalt D21520-XE Instruction Manual

DeWalt D21520-XE Instruction Manual

13mm (1/2") spade handle drill
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
INSTRUCTION MANUAL
D21520-XE
13mm (1/2") SPADE HANDLE DRILL

Advertisement

Table of Contents
loading

Related Manuals for DeWalt D21520-XE

Summary of Contents for DeWalt D21520-XE

  • Page 1 INSTRUCTION MANUAL D21520-XE 13mm (1/2") SPADE HANDLE DRILL...

  • Page 3: Definitions: Safety Guidelines

    1) WORK AREA SAFETY Definitions: Safety Guidelines a) Keep work area clean and well lit. Cluttered or dark areas invite accidents. b) Do not operate power tools in explosive atmospheres, such as in the The definitions below describe the level of severity for each signal presence of flammable liquids, gases or dust.

  • Page 4: Electrical Safety

    c) Prevent unintentional starting. Ensure the switch is in the off position f) Keep cutting tools sharp and clean. Properly maintained cutting tools with before plugging in. Carrying power tools with your finger on the switch or sharp cutting edges are less likely to bind and are easier to control. plugging in power tools that have the switch on invites accidents.

  • Page 5: Drill Safety Warnings

    MINIMUM GAUGE FOR CORD SETS WARNING: Some dust created by power sanding, sawing, grinding, drilling, and For Cable length (m): 7.5 other construction activities contains chemicals known to cause cancer, birth defects Use Cable with minimum rating (Amperes) or other reproductive harm. Some examples of these chemicals are: Tool Amperes •...

  • Page 6: Assembly And Adjustments

    SAVE THESE INSTRUCTIONS FOR FUTURE USE FIG. 1 COMPONENTS (Fig. ?) WARNING: Never modify the power tool or any part of it. Damage or personal injury could result. A. Trigger switch B. Control lever ASSEMBLY AND ADJUSTMENTS Spade Handle Assembly (Fig. 1) This spade handle can be attached either horizontally or vertically.

  • Page 7: Drilling In Wood

    Trigger Switch (Fig. 2) Drilling To turn the tool on, squeeze the trigger switch (A) shown in Figure 2. To turn the tool 1. Always turn off tool and disconnect from power supply when attaching or changing bits or accessories. off, release the trigger switch (A).

  • Page 8: Maintenance

    Drilling in Masonry Repairs Use carbide tipped masonry bits at low speeds. Keep even force on the drill but not To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment so much that you crack the brittle materials. A smooth, even flow of dust indicates the (including brush inspection and replacement) should be performed by certified proper drilling rate.
  • Page 12 701 East Joppa Road, Baltimore, MD 21286 • 82 Taryn Drive, Epping, VIC 3076 Australia 1800 444 224 (Aust) or 0800 339 258 (NZ) (JUL11) Part No. N130171 D21520-XE Copyright © 2011 D WALT The following are trademarks for one or more D WALT power tools: the yellow and black color scheme;...

Table of Contents