Extreme Networks Summit X150 Series Installation Note page 2

Installing a Summit X150 Series Switch
CAUTION
Make sure that proper ESD controls are in use before maintenance is performed. This includes but is not limited to
wrist straps that are grounded to the switch chassis and earth grounds.
Installing a Summit X150 Series Switch
The Summit X150 series switch is designed to be installed in a standard 19-inch equipment rack or
placed free-standing on a tabletop. The installation process includes the following tasks:
Install the switch in a rack or on a table.
●
Ground the switch.
●
Connect a redundant power supply (if applicable).
●
Connect the internal power supply.
●
Rack-Mounting a Summit X150 Series Switch
To mount the switch in a rack, you will need the following tools, equipment, and resources:
Mounting brackets (provided)
●
Eight screws (provided) to secure the mounting brackets to the switch
●
Four rack system mounting screws
●
The screw size will vary based on your organization's rack; screws are not provided.
Screwdriver for securing the switch to the rack
●
The screwdriver size will vary based on the requirements of your organization's rack.
To rack-mount a Summit X150 series switch:
1 Place the switch upright on a secure work surface.
2 Place a mounting bracket over the mounting holes on one side of the unit.
3 Insert the screws and fully tighten (see
Figure 1: Attaching a Mounting Bracket
33
34
35
36
37
38
39
40
41
42
43
4 Repeat steps
2
44
45
46
47
48
45 X
46 X
47 X
48 X
S o lid
O N
B lin ki
= L in
n g = k
A ct iv
ity
S h a
re d
P o rt
s
2 and 3 for the other side of the switch.
Figure 1).
SH_035
Summit X150 Series Switches Installation Note