Extreme Networks Summit Summit24 Installation And User Manual page 64

Managing the Switch
config corp ipaddress 10.201.26.11/24
config radius primary server 10.201.26.243 client-ip 10.201.26.11
config radius primary shared-secret secret
enable radius
create vlan temporary
config temporary add port 9
config temporary ipaddress 192.168.0.1/24
config temporary dhcp-address-range 192.168.0.20 - 192.168.0.100
enable netlogin ports 9 vlan temporary
User Login Using Campus Mode
To log in as a user from the client, the user will follow these steps:
1 Set up the Windows IP configuration for DHCP.
2 Plug into the port that has network login enabled.
In this example, the user will plug into port 9.
3 Log in to Windows.
4 Release any old IP settings and renew the DHCP lease.
This is done differently depending on the version of Windows the user is running:
— Windows 9x—use the winipcfg tool. Choose the Ethernet adapter that is connected to the port on
which network login is enabled. Use the buttons to release the IP configuration and renew the
DHCP lease.
— Windows NT/2000—use the ipconfig command line utility. Use the command ipconfig/release to
release the IP configuration and ipconfig/renew to get the temporary IP address from the switch.
If you have more than one Ethernet adapter, specify the adapter by using a number for the
adapter following the ipconfig command. You can find the adapter number using the command
ipconfig/all.
At this point, the client will have its temporary IP address. In this example, the client should have
obtained the IP address 192.168.0.20.
5 Bring up the web browser and enter the IP address of the switch.
NOTE
It is important to use the IP address of a VLAN that is reachable from anywhere on the network
A page will open with a link for network login.
6 Click the network login link.
A dialog box opens requesting a username and password.
7 Enter the username and password configured on the RADIUS server.
After the user has successfully logged in, the user will be redirected to the URL configured on the
RADIUS server.
During the user login process, the following takes place:
• Authentication is done through the RADIUS server.
• After successful authentication, the connection information configured on the RADIUS server is
returned to the switch:
64 Summit24e3 Switch Installation and User Guide