Summary Of Features - Extreme Networks Summit 200-24 Installation And User Manual

3
ExtremeWare Overview
This chapter describes the following topics:
• Summary of Features on page 35
• Software Licensing on page 38
• Security Licensing for Features Under License Control on page 39
• Software Factory Defaults on page 40
ExtremeWare is the full-featured software operating system that is designed to run on the Summit 200
series switch. This section describes the supported ExtremeWare features for the Summit 200 series
switch.

Summary of Features

The Summit 200 series switch supports the following ExtremeWare features:
• Virtual local area networks (VLANs) including support for IEEE 802.1Q and IEEE 802.1p
• Spanning Tree Protocol (STP) (IEEE 802.1D)
• Quality of Service (QoS) including support for IEEE 802.1p, MAC QoS, and four hardware queues
• Wire-speed Internet Protocol (IP) routing
• DHCP/BOOTP Relay
• Network Address Translation (NAT)
• Extreme Standby Router Protocol (ESRP) - Aware support
• Ethernet Automated Protection Switching (EAPS) support
• Routing Information Protocol (RIP) version 1 and RIP version 2
• Open Shortest Path First (OSPF) routing protocol
• Diffserv support
• Access-policy support for routing protocols
• Access list support for packet filtering
• Access list support for rate-limiting
• IGMP snooping to control IP multicast traffic
• Load sharing on multiple ports
Summit 200 Series Switch Installation and User Guide 35