Table of Contents
Advertisement
NOTE: It is normal for the heater "fan" to run for approximately 60
seconds when the heater shuts off after reaching the set
temperature.
To change the heat setting from high (HH) to low (LL), press the
and the
buttons on the unit at the same time.
Rotating the Plug
The plug can be rotated 180°. Just press the round button on the
right of the plug and turn.
WARNING: Only attempt to rotate the plug when the plug-in heater
is cool and unplugged.
1. Press and hold the plug rotation button on the back of the plug-in
heater.
2. Rotate the plug 180° whilst holding the rotation button on the
right of the plug.
THERMAL CUT-OFF PROTECTION SYSTEM
This heater includes an Overheat Protection System that shuts
the unit off permanently when a potential overheat temperature is
reached. If this occurs, the heater can only resume its normal
operation after resetting it. To reset the heater:
1. Press the
Power Button
the on/off switch to the 'off ' position.
2.
Unplug the heater and wait 10 minutes for the unit to cool down.
3.
After the 10 minutes, plug the unit in again and operate normally.
CLEANING AND MAINTENANCE
1. Press the Power Button
on/off switch on the side to the 'off ' position. Allow the unit to cool
down and unplug the heater before moving or cleaning.
2. Interior dust can often be removed by using a vacuum cleaner
with a crevice tool attachment.
3. To clean the enclosure, use a clean, soft and lightly damp cloth
to gently wipe off the dirt from the surface of the unit. Be sure not to
wet the heating element and switches. Allow the unit to dry
completely before use.
4. Do not use cleaning liquid or other chemicals to spray on the unit.
WARNING: Any other servicing should be performed by an
authorized service representative.
to turn the heater OFF and press
to turn the heater OFF and press the
7
81617-01 R20201125
Advertisement
Table of Contents
