Related Manuals for Hunter 73027-WH
Summary of Contents for Hunter 73027-WH
- Page 1 Plug-in Heater Plug-in Heater with Remote Control Owner s Manual Model 73027 73027-WH...
- Page 2 TABLE OF CONTENTS Grounding Instruction Thermal Cut-Off Protection System Cleaning and Maintenance 81616-01 R20210804...
-
Page 3: Safety And Warnings
INTRODUCTION Thank you for choosing the Hunter Ceramic Heater. This manual gives you complete instructions for using your heater. SAFETY AND WARNINGS READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN THE PRODUCT DESCRIBED. PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION. - Page 4 11. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, like a bed, where openings may become blocked. 12. A heater has hot and arcing or sparking parts inside. Do not use in areas where gasoline, paint, or flammable liquids are used or stored.
-
Page 5: Grounding Instructions
Grounded GROUNDING INSTRUCTIONS Plug This appliance is for household use only and may be plugged into any 120-volt AC electrical outlet (ordinary household current). DO NOT use any other type of outlet. WARNING: This unit is suitable for grounded receptacle use only. This unit has a grounded plug as shown in Figure 1. - Page 6 Operation 1. Check there is no damage to the plug-in heater. 2. Plug the plug-in heater into a 120 volts AC outlet. Be sure the plug fits tightly into outlet. When plugs fit loosely into receptacles, they may slip partially or completely out of the receptable with only the slight movement of the unit.
- Page 7 NOTE: It is normal for the heater "fan" to run for approximately 60 seconds when the heater shuts off after reaching the set temperature. To change the heat setting from high (HH) to low (LL), press the and the buttons on the unit at the same time. Rotating the Plug The plug can be rotated 180°.
-
Page 8: Cleaning And Maintenance
THERMAL CUT-OFF PROTECTION SYSTEM This heater includes an Overheat Protection System that shuts the unit off permanently when a potential overheat temperature is reached. If this occurs, the heater can only resume its normal operation after resetting it. To reset the heater: 1. -
Page 9: Warranty
These electronic control items are included in the one year limited warranty below. If any part of your Hunter heater other than the motor fails at any time within one year after the date of sale to you due to a defect... - Page 10 To obtain servicing, contact the nearest Hunter authorized service center or the Hunter Home Comfort Service Department, 980 Cobb Place Boulevard NW, Suite 100, Kennesaw, GA 30144. Please contact us before shipping your heater to us. If we authorize you to ship it to us, you will be responsible for all insurance and freight or other transportation charges to our factory service center.
Need help?
Do you have a question about the 73027-WH and is the answer not in the manual?
Questions and answers