Cleaning And Mainteinance - Electrolux EOB 395 Instruction Booklet

5. Cleaning and Maintenance
General Cleaning
Before cleaning, always allow the oven to
cool down.
When using spray cleaning products, be
careful not to spread them on the heating
elements or on the thermostat sensor.
Never use harsh abrasives, steel wool or
cleaners with bleach, as they could damage
the enamel and the oven door glass.
The Oven Cavity
The enamelled oven cavity is best cleaned whilst the oven
is still warm. It is advisable to wipe the oven over with a soft
cloth soaked in warm soapy water after each use.
However, from time to time, it will be necessary to do a
more complete cleaning, using a proper oven cleaner.
In case of particularly tough stains, you can use some
warm vinegar.
• If cooking fruits, some over-heated natual acids can
squeeze and settle on the oven enamel, causing
stains quite difficult to remove. This could affect the
enamel brightness, but it will have no consequence on
the oven performances.
To avoid these stains to be burnt out during the next
cooking, carefully clean the oven cavity after all fruits
cookings.
The Oven Door
Before cleaning the oven door, we recommend you to
remove it from the oven.
Proceed as follows:
a) open the oven door completely;
b) find the hinges linking the door to the oven (fig
6);
c) unlock and turn the small levers located on the
two hinges (fig. 6);
d) handle the door by its left- and right-hand sides,
then slowly turn it towards the oven until it is
half-closed;
e) gently pull the oven door off its site (fig. 6);
f) place it on a steady plan;
g) unscrew the two screws marked with lett. A fig.
7;
h) pull up the oven door glass and take it away
from the oven door.
Clean the oven door glass with warm water and a softh
cloth only.
Once the cleaning is carried out, refit the oven door,
following the procedure in reverse.
All manuals and user guides at all-guides.com
FO 0288
Fig. 6
FO 0027
Fig. 7
i
For the EOB 395 X model, we recommend to
clean the outer surface of the oven door with a
wet sponge, and then carefully wipe it dry with
a soft cloth.
Do not use any abrasive cleaning product, such as steel
wool or acids, as they could damage the stainless steel
surface.
Follow the same procedure for the control panel.
The Oven Door Gasket
The correct operation of the oven is ensured by a gasket
placed round the edge of the oven cavity.
Periodically check the condition of this
gasket. If necessary, clean it without using
abrasive cleaning products.
If the gasket shows to be damaged, call
you local Electrolux Service Centre. Do not
use the oven until it has been repaired.
21